ES1000 (Non-Atomic) Totalizing Payroll Recorder

2010 DST Quick Guide

Note: If you programmed your non-atomic ES1000 previously for the updated DST change dates, you should not have to program the DST change dates again for 2010. The unit remembers the start date as the second Sunday in March and the end date as the first Sunday in November. Once set, the clock automatically updates the settings every year thereafter. No further manual setting is necessary unless the law regarding the start and end dates of DST changes again.

Use the instructions below if you did not set up your clock for automatic DST change dates or for whatever reason need to change your DST programming for 2010.

General Information

To enter the program setting mode, plug the AC cord into the AC outlet and remove the silver cover. Press and hold the [SETTING START/END] button until four dashes is shown on a display and you go into setting mode.

Illustration of the programming buttons

Setting the 2010 DST Start and End Dates

  1. Press and hold the [TIME/DATE] button for two seconds.
  2. When a single digit comes up in the display, press the [TIME/DATE] button once more. The hour will begin flashing.
  3. Press the + button once to change the hour to the correct time.
  4. Press the [CARD TRANSFER SET] button once (this is the next to the last silver button on the right).
  5. Press the [SETTING START/END] button twice.
  6. Press and hold the [FUNCTION] button for two seconds.
  7. Then press the [FUNCTION] button seven (7) times. The year will start to flash.
  8. Press the + button until the display shows the number 10.
  9. Press the [CARD TRANSFER SET] button once. The month will start to flash.
  10. Press the + button until the display shows the number 3.
  11. Press the [CARD TRANSFER SET] button once. The date will start to flash.
  12. Press the + button until the display shows the number 14.
  13. Press the [CARD TRANSFER SET] button once. Wait for approximately two seconds. The year will start to flash 10.
  14. Press the [CARD TRANSFER SET] button once. The month will start to flash.
  15. Press the + button until the display shows the number 11.
  16. Press the [CARD TRANSFER SET] button once. The date will start to flash.
  17. Press the + button until the display shows the number 7.
  18. Press the [CARD TRANSFER SET] button once.
  19. Push the [SETTING START/END] button to get out of setting mode. Make sure DATE and TIME are indicated on the display and the colon is flashing. Then replace the cover and lock.
    es1000 display showing regular display

For more information, refer to your User Manual. [ download PDF version ]

Need a new set of keys for your ES1000 clock? Replacement ribbon? Time cards? Click here to visit the Acroprint Store for all your ES1000 supplies and accessories!

Click here to check out AcroTime, our powerful web-based time and attendance solution
offering anytime/anywhere access, exports to most popular payroll systems and a free 30-day test-drive.

[ Return to Time Change Index ] [ Acroprint Home Page ]